About
All feedback (738)
edenpleasureproducts (16455)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
o***3 (635)- Feedback left by buyer.
Past 6 months
Verified purchase
Excellent seller! Very fast shipping and good communications. Would purchase from again. A+++
o***3 (635)- Feedback left by buyer.
Past 6 months
Verified purchase
Excellent seller! Very fast shipping and good communications. Would purchase from again. A+++
s***a (520)- Feedback left by buyer.
Past 6 months
Verified purchase
Fast shipping and great price.
t***f (77)- Feedback left by buyer.
Past 6 months
Verified purchase
Great price. Prompt shipping.
oshgoshkalash (558)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with.
Reviews (5)
Aug 25, 2021
If you paint and sand, these are for you.
With the proper filters and a clean shave, I can stand next to a smoker and not smell smoke wearing these 3M respirators. Most importantly, the mask mitigates fumes from painting, and stops harmful particles from fiberglass dust, bedliner application, etc.
No other respirator I've used stops cigarette smells, let alone heavy paint fumes. Just be sure you select the correct filters for the job, and again, you need a clean shave for an air-tight seal.
These are far superior to other brands, and the selection of filters available is excellent. Well worth the money for the peace of mind, especially when it comes to your lungs.
Jun 26, 2021
Be careful! Loose fit allows card to slip under the ridges designed to keep card in place!
1 of 1 found this helpful First, these look very nice. Easy to insert a card without damaging it. However, mine has one glaring defect, which precludes me from placing any highly valuable cards inside of it. (I purchased this holder for an expensive 1953 Topps card that's a gift for my father.) The hinged bottom is not quite tight, which allows the holder to have a bit of play side-to-side, but even worse, allows it to spread open just enough so that, when looking at the reverse of the card, it can slip between the ridges designed to hold the card in place and the flat front plastic! Had I not noticed this, a four-figure card could've been ruined by flipping the holder the wrong direction. (Pretty un-pro for a product called ProMold.)
I am now forced to use a regular screw-down holder, with a special foam frame that allows the card to remain sandwiched in the lexan, but does not pinch the card.
I would only recommend this type of holder for commons or cards in PR condition, etc. Shame, because the look is quite nice, and the size is way better than a PSA slab, IMO.
Jun 05, 2020
Great value, no noticable added distortion.
2 of 2 found this helpful I was owner of a small audio shop for years, and worked at a few other shops, too. This crossover setup is as good as many higher priced examples. I've used this to bypass a factory amp, and it gets the job done. The ability to run woofers, mids and highs off a single, two-channel amplifier makes these little crossovers a great value. Highly recommend.